DN80 Fuel Shut-off Valve

The VIC083 safety valves. with positive action, not activated by external energy, built for the purpose of intercepting the flow of fuel to the burner to prevent the temperature of the water in the system delivery circuit from reaching the boiling point.

The valve closes due to:

Puncture or cut the capillary and/or sensor bulb. ATTENTION: As they are positive action valves, in this case it is no longer possible to reset the valve.

Raising the water temperature until it reaches the calibration point. In this case it is possible to reset the valve only if the temperature drops by at least 10 °C with respect to the calibration value indicated on the label.

NOTE:

The original copy of the calibration report is supplied with each valve. In addition to the technical data of the valve, this document also contains the serial number which is also shown on the seal fixed to the valve body. The document is stamped and validated by the INAIL technician who assisted in the calibration.

It is advisable to keep it with extreme care as in case of loss it is not possible to issue duplicates.

In compliance with:

PED Directive 2014/68/EU